Page 9 - Product Catalogue

Ceramic Adhesives

YURTBAY MIX

READY TO USE CERAMIC ADHESIVE MORTAR
YURTBAY MASTERFLEX is an acrylic emulsion based,
high performance ready to use ceramic adhesive
with reduced slip.
D2TE
TS EN 12004-1
FIELDS OF APPLICATION • It is not recommended to re-wet the material if there is crusting
Used in interior horizontal and vertical application of the coating in the material.
materials such as floor, wall ceramic, natural stone tiles etc. • Any foreign substances should absolutely not be added.
APPLICATION EXAMPLES • Gypsum and similar surfaces with high water absorption should be
• Gypsum board, gypsum plaster primed before application to reduce water absorption.
• Concrete surfaces CONSUMPTION
• Old ceramic coating Consumption amount per 1 m .
2
• Cement based plasters
• Thermal insulation boards Application Notch Size Consumption Amount (Kg/m )
2
APPLICATION DATA (23 C & 50% B.N) One-sided adhesion 6x6x6 mm 3-4 kg
O
Product color : White One-sided adhesion 8x8x8 4-5 kg
Pot life : Max. 30 min.
Application temperature : between +5 °C +35 °C Note: Provided consumption values are approximate values, and
Open time : 30 Minutes (as per TS EN 12004-1) may vary depending on the area of the application surface and the
Ready for Use : Min. 24 hours (light pedestrian traffic) application thickness.
Required time for grouting : Min. 24 hours SHELF LIFE
Full setting duration : 28 days 12 months from production date when stored in non-humid, dry
SURFACE PREPARATION environments and in original packing.
Substrates on which application will be made should be clean and The packages should be tightly closed when not in use.
sound. Any dust, oil, dirt and materials that will prevent adhesion *These values have been obtained as a result of laboratory tests
should be removed from the surface and mortar, cement, etc. in compliance with the standards. The values may vary in different
residues should be scraped off. Surface defects with depth more application environments.
than 2 cm should be repaired at least 1 day in advance.
APPLICATION BUCKET PALLET
The ready to use YURTBAY MIX should be applied on the substrate Bucket Weight /lt AMOUNT / BUCKET GROSS WEIGHT / lt SIZE / cm
using a steel notched trowel, with a notch size appropriate to the 5 30 170 80x110x50
tile dimensions. The coating material is placed on the surface and 10 24 380 80x110x70
fitted with a rubber mallet. In bonding the tiles larger than 20x20
cm to the surface, the bottom gaps of the tile should also be filled
with adhesive mortar. the tiles should be adhered to the surface
within 30 min. Wide expansion joints are required to be left for
every 50 m² during application. The prepared mortar should be
used up within 30 minutes.
APPLICATION REQUIREMENTS
• The ambient and substrate temperature should be in the range
of +5 °C to 35 °C.
• Should not be applied on frozen, thawing surfaces and surfaces
with a frost hazard.
• Application should not be made when the substrate temperature
is high, and during very sunny or extremely windy weather.
WARNINGS AND RECOMMENDATIONS
• If crusting occurs on the material during open time, the material
should be applied after being re-mixed.

6